There will also be some problems in the operation of metal mold steel. Some problems are beyond our control, so it is normal to have problems, but we must know that problems must be solved in time, so as to better ensure product quality, Therefore, we must know that if there is a problem, it must be solved in time, so as to better ensure the quality of the product.
1. If there is viscose found in the operation, the product should be taken out before the mold is closed for production, and the production with leftover material in the mold cavity is prohibited.
2. After sticking the mold, it is not allowed to hit the mold cavity with an iron tool, and a special copper rod should be used to pry out the product. The correct method is to first stick the copper rod against the surface of the mold and pry out the product. It is strictly forbidden to use the parting surface of the mold as a fulcrum to pry the product.
3. During the operation, if there is a deep hole, it is forbidden to beat the metal utensils. The correct method is to burn the iron wire red, put it into the plugging position, and pull it out after cooling, so that the sticky aluminum material can be brought out.
4. During the operation, the pins, moving sliders and thimbles on the mold should be lubricated with oil frequently. The higher the clamping pressure, the more frequent refueling. Usually, it is added once every eight hours, and then it will be pumped several times to prevent burns. .
5. During the operation, when it is found that the material head sticks to the front mold, it is forbidden to clamp the material head with pliers, so as not to damage the mold cavity with too much force. Knock out the material head at the sleeve.
mobile website
